|
LTA3
The Pulsatron Plus Series ET pump was designed to feed chemical in response to a water meter input. Typical applications include inhibitor feed for an open air-cooling tower. The Series ET provides everything you need in one unique, compact package to create a simple and cost effective metering system.
The Series ET counts pulses from a water meter. When the count exceeds a set value (either 1 or 10), the pump starts. The pump will continue to run for an adjustable time period. There are two time ranges - either 2 to 200 seconds or 12 to 20 minutes. The setting is made by selecting a time base value (200 seconds or 20 minutes) and then setting the time base percentage from 1 to 100%.
The pump includes both input and output water meter connections at the front panel. The output connection provides an isolated dry contact output of the water meter contact to operate additional pumps or timers off the same water meter.
Features: - Isolated from Earth Ground
- 120 VAC or 250 VAC @ 50/60 Hz, 5A max
- Isolated Dry Contact (Water Meter)
- Isolated Dry Contact (Water Meter)
- Mode Select Knob, Stroke Length, Stroke Rate
- Standby, On, 200 sec/count, 200 sec/10 count, 20 min/count, and 20 min/10 count
- Stroke rate and stroke length adjust 0-100% in 1% increments. Frequency turndown ratio 100:1.
- Agency approved for demanding OUTDOOR and indoor applications
Dimensions (inches): 5.4(A) x 10.3(B) x 10.8(C) x 7.5(D) x 8.9(E) See Below
Pulsatron Plus Series ET Metering Pump Datasheet
Chemical Resistance Guide
Pulsatron Pump Parts
|
|
|
|
